The all-round package. Contains all utensils from preparation to execution to preservation. With Klever quick bluing, steel (up to 3 hromium content) and iron can be blued spotlessly. Whether damaged bluing on long and short guns, complete gun bluing or the bluing of small components in trade and industry: Klever quick bluing saves tedious bluing baths, time and money. Even zinc die-cast parts, such as signal pistols, can be processed. Simple treatment: degrease the surface, apply the burnishing agent, allow to act, rinse with water, dry and spray with gun oil. ApplicationBallistol Quick Blackening should only be applied to untreated areas or areas to be repaired, as it can visually alter an already existing blackening.Clean metal parts or the areas to be blackened with Robla Cold DegreaserPolish the areas to be blackened with fine steel wool to remove any surface oxidationClean again with the degreaser - after degreasing, do not touch the metal surface with your finger to avoid creating new fingerprintsApply Quick Blackening with a blackening applicator - Allow blackening agent to act for approx. 3 minutes until a yellowish white coating is formedthen rinse the parts with cold water and dab the surfaces dry with a soft clothif you want to intensify the coloring, repeat steps 3 to 5 - if very deep coloring is to be achieved, these steps can also be repeated several timespreserve new bluing with Ballistol Universal Oil or with Gunex Gun OilContentsBALLISTOL Spray, 50 mlRobla Cold Degreaser Spray, 50 mlQuick bluing, 50 ml2 pairs of disposable nitrile gloves2 goat hair brushes2 lint-free care clothsexclamation markaetzwirkungumweltgefaerdentAchtung: Selenium dioxide, copper dinitrate, nitric acid. May be corrosive to metals. Harmful if swallowed. Causes skin irritation. Causes severe eye irritation. Toxic to aquatic organisms, with long lasting effects. If medical advice is needed, have container or label at hand. Wear protective gloves/eye protection. Keep out of the reach of children.